30
Filter blocked in water inlet hose
First, reduce the water pressure in the supply hose:
1.
Turn off the tap!
2.
Select any programme (except 0 p Spin/Empty).
3.
Select ! Start/Reload. Allow the programme to run for
approx. 40 s.
4.
Turn the programme selector to Off. Appliance is switched
off. Remove the mains plug.
5.
Clean the filter:
Disconnect the hose from the water tap.
Clean the filter with a small brush.
and/or for standard model:
Remove the hose from the rear of the appliance.
Take out the filter with pliers and clean it.
6.
Connect the hose and check for leaks.
To Next Page
Loading...
