41
Water connection
m Warning!
Danger of death from electric shock!
Danger of death if live parts are coming into contact
with water.
Do not immerse Aqua-Stop safety device in water
(contains an electric valve).
²
– To prevent leaks and water damage, you must follow the
instructions in this section.
– Only operate the washing machine using cold mains water.
– Do not connect the machine to the mixer tap of an
unpressurised hot-water boiler.
– Do not use a used supply hose. Only use the supply hose
supplied or one that was purchased from an authorised
specialist retailer.
– If in doubt, have the appliance connected by a technician.
Water inlet
²
Water inlet hose: do not kink, crush, modify or sever (strength is
no longer guaranteed).
Optimum water pressure in the mains: 100-1000 kPa (1-10 bar)
Ø When the tap is open, the water flow is at least 8 l/min.
Ø If the water pressure is higher than this, a pressure-reducing
valve must be installed.
1.
Connect the water supply hose.
m Warning!
Threads for screw connections may be damaged!
If the screw connections are tightened too much with
a tool (pliers), the thread may become damaged.
Tighten plastic screw-fittings by hand only.
to the tap (¾" = 26.4 mm):
PLQPP
Aquastop Standard
PD[
PD[
To Next Page
Loading...
