46
Before the 1st washing
The washing machine was thoroughly tested before leaving the
factory. In order to remove any water which may be left over from
the test, run the first washing cycle without any laundry.
²
The washing machine must have been installed and connected
properly. See chapter Installing from~ Page 37
1.
Check the machine.
²
Never switch on a damaged machine. Inform your customer
service. ~ Page 34
2.
Insert mains plug.
3.
Turn the tap on.
4.
Switch on the appliance.
5.
Close the washing machine door (do not load any laundry!).
6.
Select the Î Cottons 90 °C programme.
7.
Open the detergent drawer.
8.
Pour approx. 1 litre of water into dispenser II.
9.
Add standard detergent to dispenser II according
to manufacturer’s instructions for light soiling.
²
To prevent frothing, use only half the recommended amount of
detergent. Do not use any woollens or mild detergents.
10.
Close the detergent drawer.
11.
Select ! Start/Reload.
12.
Switch off the appliance at the end of the programme.
Your washing machine is now ready to use.
To Next Page
Loading...
