33
Intense noise, vibra-
tions and “wander-
ing” during spinning.
– Appliance aligned?
Level the appliance. ~ Page 44
– Appliance feet fixed?
Secure appliance feet. ~ Page 44
– Transportation protection devices removed?
Remove transportation bolts. ~ Page 39
The colon on the
0
(Ready in) display :
stops flashing.
Mains voltage too low ~ Page 26
The single dot (.)
flashes.
Undervoltage during the washing programme causes an extending
of the wash programme. ~ Page 26
Display panel/indi-
cator lights do not
function while the
appliance is running.
– Power failure?
– Fuse tripped? Switch on/replace the circuit breakers.
– If the fault occurs repeatedly, call the after-sales service.
~ Page 34
Detergent residue
on the laundry.
– Occasionally, phosphate-free detergents contain water-insoluble
residue.
– Select
q (Rinse) or brush the laundry after washing.
¯‹ appears in the
display panel in re-
load mode.
– Water level too high. Not possible to add laundry. Close the
washing machine door immediately, if necessary.
– To continue the programme, select the
! Start/Reload button.
v + ¯‹ and the !
Start/Reload button
are flashing in the
display panel in re-
load mode.
Not possible to add laundry. Wait until v + ¢“† are lit
(approx. 1 min).
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
– Switch off the appliance and pull out the mains plug.
– Turn off the water tap and call the after-sales service. ~ Page 34
Faults Cause/Remedy
To Next Page
Loading...
