26
2. Target Selection
FIRST, BEST, LAST, XR or FOG should be ashing. You can toggle between target modes by
pressing and releasing the RANGE button. Conrm your selection by pressing and releasing the
MODE button which will save your setting and index to the next setting for conguration. If you
do not press and release the MODE button the rangender will save your selection and turn o.
BEST Target can be used for most situations, however, when hunting through foliage or in high
grass the LAST Target is recommended. XR mode can be used for extreme distances but the
range result takes approximately 1 second to calculate. FOG mode can be used in misting or
foggy environments.
3. Display Brightness
Display Brightness (Lumatic OLED Display) – AUTO will be used in most cases which leverages
the ambient light sensor located in the objective of the rangender. This sensor samples the
ambient light conditions and automatically adjusts the display to the local environment. You can
change this to 9 individual settings: LOW 1 – 3, MED 1-3 and HI 1-3. Note – if you accidentally
leave the unit on Setting LOW 1 you may not be able to see the display. If this occurs, go into a
dark environment and change the illumination setting.
To Next Page
Loading...
Need help?
General
