118
C4 Manual Rev 7.5.2
RS, RSA - Request status byte ........................................ 61
RS-232
See EIA-232 .................................................... 10
Run Time Pre-read Errors ........................................... 49
Invalid Loop Count Error ......................................... 50
No Probe 2 Error ................................................ 50
Setpoint Out of Range Error ....................................... 50
SC Set probe correction.............................................. 66
SD Set UUT temperature differential limits ............................ 69
Serial number display............................................... 24
Serial port ..................................................... 10, 55
Settings ....................................................... 79
Servicing considerations - service WARNINGS.......................... 101
Setpoint
Displaying/changing in local mode .................................. 40
Setpoint error ..................................................... 41
Setpoint Out of Range Error.......................................... 50
Setup mode .................................................... 10, 79
Setup parameter integrity checking.................................... 32
Setup parameters
Autostart mode .............................................. 80, 82
Blower shut-off mode.......................................... 80, 83
Chamber/platform operating limits ................................. 81
Changing values ................................................ 82
Display ........................................................ 81
EEPROM values ................................................ 66
EIA-232 settings ................................................ 79
GPIB address ................................................... 79
Modifying ................................................... 66, 79
Modifying temporarily in remote mode .............................. 66
Number of probes............................................. 79, 82
Permanent changes to in remote mode............................... 66
PID constants............................................. 79, 80, 83
Probe correction (software probe calibration)....................... 80, 83
REFER key enable/disable ........................................ 80
Remote communication port select .................................. 79
Restoring to default values ........................................ 27
SC Set probe correction ........................................... 66
SRAM values ................................................... 66
Temperature scale (
/C or /F) ....................................... 80
UP Write current parameters to NV memory ......................... 69
UP command ................................................... 66
UUT operating differential limits ................................... 81
UUT operating limits............................................. 81
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...