63
C4 Manual Rev 7.5.2
7.5 Operation Information Queries & Commands
7.5.1 RS, RSA Request Status Byte
These commands retrieve the status byte. See Section 7.8.1.
If RS is used, the status byte is returned as a one byte binary value imbedded in
an ASCII text string as follows:
RS<status byte><CR><LF>
If RSA is used, the status byte is returned as a two byte ASCII hex string
imbedded in an ASCII text string as follows:
RSA<space><2 character ASCII hex string><CR><LF>
Example:
RSA 47<CR><LF>
The syntax for the command is:
RS<CR><LF> Request 1 byte binary value
RSA<CR><LF> Request 2 byte ASCII hex value
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...