SIGMA SYSTEMS C4 - 1.5.22 Remote Mode Setup Parameter Commands

To Next Page

To Previous Page

C4 Manual Rev 7.5.2

1.5.22 Remote Mode Setup Parameter Commands

SC Set Correction (Calibration) for Probe ........... See Section 7.6.1

WP Set PID Constants ........................... See Section 7.6.2

BF Turn Blowers Off ............................ See Section 7.6.3

BO Turn Blowers On ............................ See Section 7.6.3

SL Set UUT Temperature Limits.................. See Section 7.6.4

SD Set UUT Temperature Differential Limits........ See Section 7.6.5

UP Write SRAM Parameters to EEPROM ........... See Section 7.6.6

1.5.23 Remote Mode IEEE-488 (GPIB) Monitoring

The IEEE-488 bus controller is automatically reset if a problem is detected. No

message to the user is generated as no data is typically lost in the process.

1.5.24 Setup Mode Easier Parameter Access

Setup parameters may now be accessed directly by number rather than having to

scroll the entire list. If scrolling is used, there is now a backup key so the list can

be scrolled in either direction. Likewise, for parameters that are chosen from a

list, the list can be scrolled in either direction or the parameters can be keyed in

directly without scrolling the list. See Section 8.1.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com