SIGMA SYSTEMS C4 - Page 121

120
C4 Manual Rev 7.5.2
The Differential Term ........................................... 108
The integral term............................................... 107
The proportional term ........................................... 107
WP Set PID constants ............................................ 67
UP Write current parameters to NV memory ........................... 69
UUT operating limits ............................................... 81
UUT temperature differential limits ............................. 37, 69, 81
UUT temperature limits ............................................. 37
SL Set UUT temperature limits .................................... 69
Watchdog timer .................................................... 31
Web site ......................................................... 110
WP Set PID constants............................................... 67
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com