65
C4 Manual Rev 7.5.2
Note: Byte 00 of this string is the same error byte that is available using RE and
REA commands.
Byte 01 of this string is the same EIA-232 status byte that is available
using RE and REA commands in EIA-232 mode. The EIA-232 version of
the status byte is used in the Error/Status String, Byte 01 even in IEEE-
488 mode.
Byte 00 & the Error, Setpoint Reached, and Interval Complete bits of byte
01 (as well as bytes 02-31) and the Error Byte are cleared each time a QE or
QEA command is issued.
The syntax for the command is:
RS<CR><LF> Request binary value
RSA<CR><LF> Request ASCII hex value
The QE command will return QE<space><a fixed length 64 byte binary
string><CR><LF>. Total return string length=69 bytes, including terminators.
The QEA command will return the 64 bytes of error/status data in 2 character per
byte formatted ASCII hex in 4 lines of 16 error/status bytes each formatted as
follows:
For each line:
QEA<space><first byte number in two ASCII digits><triple space><then 16 bytes
of error/status data as ASCII hex with 1 space between bytes 0-7, three spaces
between bytes 7-8, one space between bytes 8-15><CR><LF> as follows:
QEA 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00<CR><LF>
QEA 16 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00<CR><LF>
QEA 32 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00<CR><LF>
QEA 48 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00<CR><LF>
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...