SIGMA SYSTEMS C4 - Page 93

92
C4 Manual Rev 7.5.2
Step
Number
Displayed
Step .
Substep
Keys to press Description of entry
0
00.0
CLEAR/ENTRY 45.2 ENTER
Go to 45.2/C
00.1
CLEAR/ENTRY 5 ENTER
Use 5 minute ramp time
00.2
CLEAR/ENTRY 2 ENTER
Hold temperature for 2 minutes
00.3
DISP/CNTL
Accept default value of 1
00.4
DISP/CNTL
Accept default value of 1
1
01.0
CLEAR/ENTRY 32.3 ENTER
Go to 32.3/C
01.1
CLEAR/ENTRY 2 ENTER
Use 2 minute ramp time
01.2
CLEAR/ENTRY 6 ENTER
Hold 32.3/C for 6 minutes
01.3
DISP/CNTL
Accept default value of 2
01.4
DISP/CNTL
Accept default value of 1
2
02.0
CLEAR/ENTRY 50.1 ENTER
Go to 50.1/C
02.1
DISP/CNTL
Accept default value of 0
02.2
CLEAR/ENTRY 9900 ENTER
Do not hold at this temperature
02.3
DISP/CNTL
Accept default value of 3
02.4
DISP/CNTL
Accept default value of 1
3
03.0
CLEAR/ENTRY -10.0 ENTER
Go to -10/C
03.1
DISP/CNTL
Accept default value of 0
03.2
CLEAR/ENTRY 3 ENTER
Hold -10/C for 3 minutes
03.3
CLEAR/ENTRY 100 ENTER
End program
03.4
DISP/CNTL
Accept default value of 1
To run this program, set the program pointer to the first program step (00) and
then start the program using the following key sequence:
00 <DISP/CNTL><START/STOP>
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com