Sigma BM30 - Operating Instructions

The machine must be placed on the floor regulating its steadiness by means of the little foot that
can be regulated in its highness..
Next to the machine, a lead must be installed; wires section of 1,5 mm2 at least and tap with
blocked plug.
Make sure that volt, Hz, kw comply with the ones indicated on the rating plate of the machine.
ATTENTION: At the start of the power supply a differential must be fitted with leakage current of
0,03A (Ampere).
OPERATING INSTRUCTIONS
The machine must have the bowl attached and the protection grid closed otherwise the
protections and safety devices prevent the mixer from working.
DO NOT REMOVE OR TAMPER THE PROTECTIONS AND THE SAFETY DEVICES, EITHER
ELECTRIC OR MECHANIC, THE MACHINE IS EQUIPPED WITH.
1. The bowl must be attached to the mixer BEFORE attaching the
agitators. Make sure that the bowl lift lever is in the down position.
2. Place the bowl onto the mixer making sure that the holes on
each side are securely placed over the pins on the bowl
support. Secure the bowl by pushing the bowl clamps on either
side back so that the clamps rests on the bowls handles.
3. Rotate the bowl guard so that it rests in the open position
and lower the bowl in its resting position. Select the
appropriate tool and insert it onto the tool shaft. Move the
agitator so that the notch on the agitator fits over the pin on
the tool shaft as shown in the figure.
4. Lift completely up on the bowl lift lever until it locks into
position. Insert the ingredients into the bowl and start the
mixing process.
5. Press the main button (see pos.1 of the exploded view). Rotate
the timer ( pos.3) into ON position so to have a continuous