Page 21:X
SIGMA TANDEM SYSTEM OWNER’S MANUAL
11301 - 00.00.0000 Section 2: Equipment • Chapter 3 - Packing the Reserve w/ Skyhook
Thread the pull-up cord through the bottom
kicker flap (flap #1). If equipped with a Cypres be
sure to pass through the cutter before passing
through flap #1.
You may evaluate the length of your closing
loop by the following method: Press the #1 flap
firmly down while pulling with adequate force
on the pull-up cord. The top of the closing loop
should extend beyond the bound edge of flap
#1 by a 1/4" to 1/2". This will help ensure the
proper length closing loop is being used. Secure
flap #1 with temp pin.
Fold the bridle vertically along both sides of the
center grommet and place these folds under
flap #1. Leave approximately 5' of bridle
unstowed below the pilot chute.
To Next Page
Loading...