Page 23:X
SIGMA TANDEM SYSTEM OWNER’S MANUAL
11301 - 00.00.0000 Section 2: Equipment • Chapter 3 - Packing the Reserve w/ Skyhook
Your rig is equipped with the new Skyhook II. It differs from the original
Skyhook in the following ways:
1. It is anodized blue.
2. The “To Pilot Chute” instruction is laser etched on the top surface.
3. There is a holographic serial number label under the surface.
4. There are two Lexan cover pieces – on each side.
5. The Lexan pieces have small holes drilled in them for safety tie thread.
6. The upper attachment tape is red.
7. The label on the rig has been updated to reflect some of these changes.
The Skyhook II’S dimensions are exactly the same, and it functions in exactly the same way
as the original Skyhook. Therefore, it is fully compatible with any Relative Workshop rig
set up for the original Skyhook.
Reasons For The Changes
1. The blue anodizing makes it easier to see damage to the hook section, while the second
Lexan cover piece better protects the hook from any damage.
2. The laser etching is much easier to read, and the holographic serial number seal makes
it much easier for us to keep track of different Skyhook batches. Please notice that
while the arrow on the Skyhook II points the same way as the original Skyhook, the “to
pilot chute” text is flipped to make it “right side up” when viewed from the top of the
rig.
3. Sealing the Skyhook lanyard with a single piece of red rigger seal thread passed
through the holes in the two Lexan cover pieces (instead of tacking the red lanyard to the
freebag bridle, as was done in the original Skyhook) results in far greater percentage of
freebags still attached to the broken away main all the way to the ground. There is no
chance of needle damage to the bridle from successive tacking with a dull needle.
4. Making the upper (toward the pilot chute) Skyhook attachment tape red makes it even
less likely that someone, will some day sew a Skyhook to the bridle backwards.
SKYHOOK II ADDENDUM
To Next Page
Loading...