EasyManua.ls Logo

Sigma TANDEM VECTOR - Lexan Cover Piece

Sigma TANDEM VECTOR
175 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 27:X
SIGMA TANDEM SYSTEM OWNER’S MANUAL
11301 - 00.00.0000 Section 2: Equipment • Chapter 3 - Packing the Reserve w/ Skyhook
Lay the bridle over flap #2 with the Skyhook
facing up. Lift the Lexan cover slightly, rotate
the Skyhook enough to slip the loop on the
end of the red Skyhook lanyard over the
Skyhook, and rotate back into position. The
Skyhook should be held firmly in place
between the two pockets with less than ¼” of
play. (Note: It should take a force of 5-7 lbs. to
pull the red or green flex-tab out of its pouch,
at a 180 degree angle to the mouth of the
pouch.)
The Skyhook has a Lexan cover piece
designed to:
1. Hinder anything but the Skyhook Lanyard
from entering the Hook-slot.
2. Lower the chance that the hook area might
be damaged by use or misuse
Make sure this cover is in good condition and
the hook area is smooth and free of burrs.
Fold the bridle over the edge of flap #2, and
insert the GREEN flex-tab on the freebag bridle
into the GREEN pocket on the #2 flap.

Table of Contents