AFTER SALES SUPPORT
1300 777 137
service@unclebills.com.au
MODEL: EA0863 PRODUCT CODE: 59016 12/2018
19
Manual-tuning
Press (do not hold) the or button repeatedly. The FM tuner will search up or down the FM band
by 0.05Mhz increments for each press.
NOTE: Be sure not to press and HOLD the or button – if you hold the buttons down the
tuner will commence the auto-search function.
NOTE: Depending on the area the Jukebox is located, you may need to either adjust the antenna
position or the Jukebox location to gain better reception.
CD Player
The Jukebox features a CD player with MP3 compatibility. To play a CD, follow the steps below.
1. Ensure to remove all protective packing material from the CD player. If these are not removed, the
CD tray will not open.
2. Press the ON/OFF (Main Power) button (No. 6 on the Jukebox parts list) to turn the Jukebox on.
The unit will automatically enter standby mode.
3. Press the STANDBY button (No. 25 on the Jukebox parts list or No. 1 on the Remote Control
Function List) to wake the Jukebox from standby mode. The unit will automatically enter FM
Radio mode.
4. Press the MODE button repeatedly until the LED display shows “----” for CD player mode.
5. Press the
(Open/Close) button on the control panel, or the EJECT button on the remote control
to open the CD tray.
6. Load the CD on the CD tray, with the label facing up and the shiny side facing down.
7. Press the
(Open/Close) button on the control panel, or the EJECT button on the remote control
again to close the CD tray.
NOTE: Do not forcibly push the CD tray to close it as this may cause a malfunction.
Instructions (cont.)
To Next Page
Loading...
