UM-FULL-30SL rev A 5
VALET MODE
The valet switch allows you to temporarily bypass all alarm functions eliminating the need to hand your transmitter to
parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however,
the remote panic feature and remote door locks will remain operational.
Enter Valet Mode:
1. Turn the ignition to “ON\OFF\ON” position.
2. Push and hold the valet switch for 3 seconds or until the LED turns on. The LED will remain on as long
as the system is in “Valet Mode”.
Exit Valet Mode:
1. Return to normal operation, turn ignition “ON\OFF\ON".
2. Push and hold the valet switch for 3 seconds; the LED will turn off indicating the system is exiting the “Valet Mode”.
CAR LOCATOR
Under armed mode, press the button to activate the car locator function. The horn or optional siren will chirp 6 times
and the parking light will ash 12 times to assist you in easily locating your car.
PANIC FUNCTION
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of emergency.
1. Press and hold the button for 3 seconds. The alarm will immediately sound.
2. During panic mode, the normal function of this transmitter button will be disabled. The transmitter and buttons
can be used to lock and unlock the door (if the option is installed). However, once the button is pressed,
the vehicle’s starter disable device (where installed) will be disengaged allowing the vehicle to start.
3. To stop the alarm, press the lock button on the remote control or press the lock button for 3 seconds.
4. If the button is not pressed, the alarm will automatically stop after 30 seconds.
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
Light impact will trigger the warn-away signal.
Heavy impacts / Doors open /(if installed) Hood open / (if installed) Trunk open / Turning on the ignition key will
trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The horn or optional siren,
parking lights, and dome light will turn on for 30 seconds, alerting of an intrusion. Then it will stop and automatically
reset and re-arm. If the any one of the sensors or detectors is still active, the alarm system will sound a
maximum of 3 times of 30 second cycles.
Noise Abatement Circuit:
Your system has a “Noise Abatement Circuit” which prevents annoying repetitive trigger sequences due to faulty door pin
switches or environmental conditions such as thunder, jackhammers airport noise, etc.
Here’s how “Noise Abatement Circuit” works:
The alarm triggers ve times. Each time, the same sensor or switch has triggered the alarm; the “Noise Abatement Circuit”
will interpret this pattern of triggers as a false alarm. After the third trigger, the “Noise Abatement Circuit” ignores, or
bypasses that sensor or switch until a different sensor or switch is triggered.
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently:
If the alarm is triggered by an open door for three full cycles, the doors will be bypassed until the trigger ceases.
To Next Page
Loading...
