19"
"
! When using “Continuous” mode, you cannot pause the timer. If you stop the timer, any
subsequent press of this key will reset the timer to zero.
! The choice of Timer option will be displayed on the treatment screen.
Insertion Delay (automatic current activation mode)
The Sensor Delay key is used to work in the automatic current
activation mode, without the pedal.
• The “Sensor Delay” is the interval of time between the beginning of your insertion into the
follicle and the activation of current passage. This delay time can be modified to suit the
technician’s dexterity and difficulty encountered at the treated area. The delay may be
set from 0.5 sec to 10 sec., in 0.10s increments.
• This mode will contribute to the technician’s comfort and reduce lengthy work fatigue.
• Using the “Sensor Delay” necessitates a certain amount of dexterity. The probe must
always be accurately inserted into the follicle at the moment of current activation.
Note:
• It is not recommended to work with the “Sensor delay” mode when work areas present
difficult insertions or tight follicles.
• If you are not familiar or comfortable with the Insertion delay technique, set the delay
time to 2.5 seconds or longer.
Insertion counter
Registers the number of times the current is actually activated during
a specific treatment. Pressing the “Insertion” key for more than a
second will reset the insertion counter.
Sound
At the end of each insertion, the unit beeps to indicate that it is safe for
the needle to be removed from the follicle. If you wish to use the visual
“satellite” signal, the beep can be silenced by pressing the “Beep” key.
Screen brightness
This key serves to adjust the brightness of your screen. The screen is
set at maximum brightness by default. If you wish to dim the screen,
press the key repeatedly until the desired brightness is reached.
Brightness will loop around from high to low when the highest setting is reached.
To Next Page
Loading...