12
Preparing the seat unit
(continued)
12.3 Fit the bumper bar to the seat unit by
placing the metal ends of the bumper
bar into the xing points on the seat
unit. Wait to hear the bumper bar
‘click’ into place.
WARNING: Always ensure
your bumper bar is attached
when your child is in the seat
unit.
NOTE: The apron comes in 2 parts.
To use the apron with the seat
unit, the lower part of the apron
will be needed and should be
zipped to the front section.
12.4 Slide the apron ap clips onto the
attachment points on the inside of
the seat frame. Fold the apron ap
over the bumper bar to enclose and
secure your child. To secure, release
and adjust the harness see points
(15.1-15.5)
12.3
12.4
To Next Page
Loading...
