8
Using your bumper bar on the
carrycot
Your Surf Carrycot uses the same Surf
bumper bar as your seat unit. It can be
fully or partly removed.
5.1 To attach, simply press both ends of
the bumper bar into the connector
points on the seat unit. Wait for it to
‘click’ in place.
5.2 To detach, press the bumper bar
release button on the carrycot frame
with one hand and pull the bumper
bar away from the connector point
with the other hand. The bumper bar
will rotate.
To detach both sides repeat point (5.2)
above. With one side of the bumper
bar removed the carrycot is easily
accessible.
WARNING: The bumper bar
must be securely connected
at all times when in use. The
safety of your child is your
responsibility.
Using your hood on the carrycot
6.1 Zip the back of the Surf hood to the
top of the Surf Carrycot frame taking
care to engage the zip properly.
6.2 Your Surf hood ts to the carrycot
frame by pressing the hood clips
down onto the frame below the round
black plastic locator.
6.3 Your Surf hood can be used in 4
positions. Fully open, semi-open,
semi-open with viewing window, and
fully covered.
5.2
5.1
6.1 6.2
6.3
To Next Page
Loading...
