Using your Surf from birth with
the carrycot.
Remove all packaging material from your
Surf Carrycot.
3.1 First erect the carrycot outer. Lay the
carrycot outer down with frame upper
most. Press the 2 x metal bars into the
locators on internal base of carrycot.
A small groove in the locator holds the
frame in position.
3.2 Attach the carrycot liner to the
carrycot outer. Fasten each inner zip.
There is one at each end of the liner.
3.3 Pass the two D-shaped parts of the
liner between the liner and the outer
and fasten the velcro patches to secure
the liner in place.
3.4 Place the mattress into the base of
the liner.
3.5 Zip your Surf hood to the zip on the
carrycot outer.
3.6 Attach the hood to the frame by
pressing down on the hood attachment
clips on each side of frame.
3.7 To t the apron, place the apron over
the top of the carrycot. Secure in place
by sliding the apron clips over the
attachment points inside the
carrycot frame.
NOTE: The Apron comes in 2 parts. To use
the apron with the carrycot, the lower
part of the apron will need to be zipped
o rst. Please keep the lower part in a
safe place.
WARNING: ONLY USE ON A FIRM,
HORIZONTAL LEVEL AND DRY
SURFACE.
CAUTION: The head of the child
in the carrycot should never be
lower than the body of the child.
3.1
3.4
3.5
3.6
3.7
3.2
3.3
To Next Page
Loading...
