15 GB
In the imperial / avoirdupois system:
– Fluid ounces (fl´oz) water: “WATER” is shown in the
LC display.
– Fluid ounces (fl´oz) milk: “MILK” is shown in the
LC display.
Press the ON / OFF button
3
. The product is now in
weighing mode. The measuring unit is shown under or to
the left of the weight indication in the LC display
5
.
Press and hold the ▼UNIT button
6
for about 2 seconds
to change the unit of weight (g / lb:oz).
The weight of “0” is shown in the LC display
5
. Place a
suitable bowl or container on the weighing surface
2
and press the ▲ZERO / TARE button
7
. Again, the
weight “0” is shown in the LC display
5
. The weight of
the bowl / container is no longer included.
Place the item to be weighed in the bowl / container. The
weight of the item is shown in the LC display
5
.
Note: If no button is pressed for 2 minutes and the
weight is not changed, the readout in the LC display
5
always returns to the clock mode.
Tare (TARE function)
You can set a weight of “0” again, so that you can weigh out
another item.
Note: A small circle-symbol appears in the left of the LC display
5
as soon as the product is switched on. A weight of “0” is
shown and ready for weighing. The circle-symbol disappears
as soon as the TARE function is used or place an item on the
weighting surface
2
.
To do this press the ▲ZERO / TARE button
7
once. The
message “TARE” appears in the LC display
5
. Again, a
weight of “0” is shown in the LC display
5
.
To Next Page
Loading...
