GB
│
IE
│
15 ■
SLE 200 B2
DEHUMIDIFICATION
This programme offers you the option of setting the desired air humidity level that
should be achieved yourself.
♦ Press the UP button a or the DOWN button z to set the desired
humidity in 5% steps between 30% and 80%. The set value flashes on the
display p for approx. 5 seconds and then the current relative humidity
value is shown again.
Additionally, you also have the option to select the setting if you want to
make a setting below 30% relative humidity. This setting allows you to achieve
a very low humidity as the dehumidification runs permanently.
NOTE
► The minimum humidity that can be achieved in
mode is dependent on
many factors, such as the room size or the ambient temperature, etc.
Therefore, it is not possible to define a generally applicable minimum value.
DRY LAUNDRY
You can use this programme to dry damp laundry or textiles faster. Turn the
appliance so that the air flow from the air outlet 8 is directed towards the
garments you want to dry. Changes in the desired humidity are not possible in
this programme.
Timer function
The appliance is equipped with a timer function that can be activated for both
programmes. One of 24 switch-off times, ranging from 1 to 24 hours, can be
selected. Once the set time has elapsed, the appliance switches off permanently.
♦ While the appliance is running, press the UP button a and the DOWN
button z at the same time. The
TIMER LED i lights up, and
flashes
on the display p.
♦ Press the
UP button a or the DOWN button z to set a switch-off time
from 1 to 24 hours. The selected switch-off time flashes on the displayp for
approx. 5 seconds and then the current relative humidity value is displayed
again.
♦ To stop the timer prematurely, press the
UP button a and the DOWN
button z at the same time again. Then press the UP button a or the
DOWN button z to set the timer to . After around 5 seconds, the
TIMER LED i goes out and the display p shows the current relative
humidity value.
To Next Page
Loading...
