Silvercrest 56861 - Set the Overload Warning Value

20 GB
Operation
Q
Delete maximum values
j Use the “UP” button
5
to select one of the two maxi-
mum values (see “Maximum current”, “Maximum power
consumption”).
j Keep the “SET” button
2
pressed for approx.
3 seconds to set the maximum value to 0.
Q
Set the overload warning value
Note: in this mode you have a choice between two overload
warning values. You can set an overload warning value for
the current (A) and an overload warning value for the power
consumption (W).
Note: the overload warning value for power consumption
(W)
8
is set by default to 0,0 W on delivery.
Proceed as follows:
1. Press the “UP” button
5
until the overload symbol
7
(“OVERLOAD”) appears in the top third of the LC
display
1
.
2. Now press the “SET” button
2
. The ampere symbol
9
starts to flash.
3. Press the “UP”
5
or “DOWN” button
4
to select either
56861_Energiekostenmessgeraet_Content_GB-HU-SI-DE.indd 20 30.11.10 14:12