26 GB
Operation
power cost meter then works on the basis of this flat rate
round the clock.
Note: make sure that the standard display (see “Display
current”) appears in the top third of the LC display
1
.
1. Press the “DOWN” button
4
until the price per KWh
symbol
19
(“PRICE KWh”) appears in the centre of the
LC display
1
.
2. Press the “UP” button
5
so that “- -:- -” appears in the
bottom third of the LC display
1
.
3. Press the “SET” button
2
. The first digit begins to flash.
4. Press the “UP”
5
or “DOWN” button
4
to set the
units digit before the decimal point of the current price
per kWh in Euro (€). Example: 1.000
5. Press the “SET” button
2
to move to the next digit.
6. Press the “UP”
5
or “DOWN” button
4
to set the
hundreds digit of the current price per kWh in Eurocent (€).
Example: 1.100
7. Press the “SET” button
2
to move to the next digit.
8. Repeat step 6 to set the tens and units digit. Example: 1.111
9. Press the “PRICE” button
3
to confirm your entry.
Note: the setting made here affects the “Display energy
costs” function.
56861_Energiekostenmessgeraet_Content_GB-HU-SI-DE.indd 26 30.11.10 14:12
To Next Page
Loading...