EasyManua.ls Logo

Silvercrest CRB-631 - Speaker Connection

Silvercrest CRB-631
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation - CRB-631
13
En
g
lish
Speakers
Connect the speakers in accordance with the following diagram; incorrect connection
can cause damage to your radio or speakers.
Front left
Front right
Rear left
Rear right
Correct connection Incorrect connection
Caution!!
Only use speakers which are not connected to ground.
Only use speakers with a minimum rating of 30 W; weaker speakers could be
damaged at a high volume.
Only use speakers with an impedance of 4 ~ 8 (ohm). Speakers with a higher or
lower impedance could cause damage to your car radio.
Do not use speakers with a 3-wire connection and never connect the negative
pole of the speaker to the vehicle ground (GND). The car radio CRB-631 is
equipped with a BTL circuit (bridging circuit) and each speaker must therefore be
connected with insulated wires as shown in the wiring diagram.
The speaker cables and/or an optional external power amplifier must always be at
least 30 cm away from the antenna and/or all antenna extensions.

Related product manuals