Why is there no sound coming from my Silvercrest KH 2382 Car Receiver?
If you're not getting any sound from your Silvercrest Car Receiver, there are a few potential reasons: * The volume might be set to the minimum. Try increasing the volume. * The cables might not be connected correctly. Double-check all cable connections. * The sound might be switched off. Press the MU button to turn the sound back on.
Why won't my Silvercrest KH 2382 load or eject the CD?
If your Silvercrest Car Receiver is having trouble loading or ejecting a CD, consider these possibilities: * A CD might already be in the device. Remove the CD. * The CD might be inserted upside down. Insert the CD with the inscribed side facing up. * The CD might be dirty or defective. Clean the CD or try a different CD. * The temperature in the car might be too high. Let the vehicle air out until the temperature drops to an operational level. * There might be condensation on the laser lens. Turn the device off for a few hours and then try again.
What to do if function buttons are not functioning on Silvercrest Car Receiver?
If the function buttons on your Silvercrest Car Receiver aren't working, here are a couple of things to check: * There may be a malfunction. Press the RESET button. * The face plate might not be installed correctly. Make sure the face plate is properly installed.
Why does the CD jump in my Silvercrest Car Receiver?
If your CD is skipping while playing in your Silvercrest Car Receiver, it could be due to these reasons: * The mounting angle might be exceeding 30°. Correct the mounting angle. * The CD might be very dirty or defective. Clean the CD or try a different CD.
Why is the radio and/or automatic station saving not functioning on my Silvercrest KH 2382?
If the radio or automatic station saving isn't working on your Silvercrest Car Receiver, check the following: * The antenna cable may not be connected properly. Ensure the antenna cable is correctly connected. * The station signals might be too weak. Try setting the station manually.
What to do if the Silvercrest Car Receiver's USB port does not function?
The USB port is intended for devices that function according to the USB standard. Not all market available devices conform to this standard. It is possible that a device is connected that does not function according to the USB standard. Connect a device that functions according to the USB standard. Make sure that the data carrier is formatted for the FAT32 file system.
Why is station memory not functioning on my Silvercrest KH 2382?
The station memory may not be working because connection 4 in the ISO block A (Permanent positive) is not connected correctly. Check the cable connections.
What to do if my Silvercrest Car Receiver fails with burnt CDs?
Check the burnt CD in another playback device.
What to do if my Silvercrest KH 2382 won't switch on?
If your Silvercrest Car Receiver isn't turning on, it could be due to the following reasons: * The ignition might not be switched on. Turn the key to switch the ignition on. * The fuse might be defective. Replace the fuse.
What to do if Silvercrest KH 2382 Car Receiver card reading device does not read the cards?
If the card reading device on your Silvercrest Car Receiver isn't reading cards, check the card. Slide it in with the inscribed side facing to the right. Make sure that the data carrier is formatted for the FAT32 file system.
General| Brand | Silvercrest |
|---|---|
| Model | KH 2382 |
| Category | Car Receiver |
| Tuner Bands | FM/AM |
| Equalizer | Yes |
| Supported audio formats | MP3, WMA |
| USB port | Yes |
| AUX input | Yes |
| Output power | 4 x 45W |
| Power Output | 4 x 45W |
| Bluetooth | Yes |
| Radio | Yes |
| Display | LCD |
| Remote Control | Yes |
| Compatibility | Universal |
To Next Page