EasyManua.ls Logo

Silvercrest DA COLLO SNL 15 B1 - Telephone functions; Troubleshooting

Silvercrest DA COLLO SNL 15 B1
64 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SNL 15 B1
30 
GB
MT
Handling and operation
Pairing the speaker with a Bluetooth
®
device
Ensure that the speaker is switched off and the Bluetooth
®
device
is switched on.
Set the Bluetooth
®
device so that it scans for other Bluetooth
®
devices. A detailed description of how to do this can be found in the
operating instructions for your Bluetooth
®
device.
Press and hold the button 0 for about 2 seconds to switch
the speaker on. You will immediately hear a series of beeps and
the operating LED 6 lights up white briefly. You will then hear a
single beep and the operating LED 6 flashes white rapidly. The
Bluetooth
®
function is now activated automatically.
Select the entry SNL15B1 from the list of found devices on your
Bluetooth
®
device and, if required, enter the code 0000 to
connect the two devices. If the pairing is successful, you will hear a
short beep. The speaker is now in standby mode, and the operating
LED6 flashes white.
Start playback on the Bluetooth
®
. The operating LED 6 flashes
roughly every 8 seconds.
Press and hold the button 0 for about 2 seconds to switch the
speaker off and deactivate the Bluetooth
®
function. You will hear
a series of beeps. The operating LED 6 lights up briefly orange
before going out.
NOTE
If you do not establish a connection between the speaker and your
Bluetooth
®
device within 10 minutes, the speaker will switch off
automatically. If this happens, you will have to switch the speaker
back on before restarting the pairing process.
If the speaker stops receiving a signal while in Bluetooth
®
mode, the speaker will switch off automatically after around
10minutes.
The next time you turn on the speaker, it will connect automatically
to the last-connected Bluetooth
®
device. If your Bluetooth
®
device does not reconnect to the speaker automatically, you will
have to re-establish the connection manually. A detailed descrip-
tion of how to do this can be found in the operating instructions for
your Bluetooth
®
device.
IB_338000_SNL15B1_LB5.indb 30 31.07.2020 10:26:14

Table of Contents

Related product manuals