EasyManuals Logo

Silvercrest HG00708A User Manual

Silvercrest HG00708A
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
15 GB/IE
Press the TIME / SET button
9
for approx. 2 seconds. The 24 hour
clock (
) flashes on the display
1
.
To switch between the 24 hour clock ( ) and the 12 hour clock
(
), press the VOL + / MIN -button
6
or VOL - / HR -button
5
.
To apply the setting, press the TIME / SET button
9
again.
Press the TIME / SET button
9
. The time flashes now on the
display
1
.
To set the hour, press or hold the VOL - / HR -button
5
.
To set the minutes, press or hold the VOL + / MIN -button
6
.
To apply the set time, press the TIME / SET button
9
.
Note: If the 12 hour clock has been set, from 12:00 midday a dot
(PM) appears in the upper right corner of the display
1
Note: If the device is disconnected from the power supply and no
batteries have been inserted the time, alarm clock, station memory
will be erased.
Switching the radio on and off
Note: You can set the frequency range UKW (FM) from 87.5 to
108.0 MHz and MW (AM) from 522 to 1620 kHz.
However, it may be that diverging national regulations in different
countries exist regarding the permissible broadcasting frequency ranges.
The reception may be a punishable offense in some countries. Therefore,
ensure the following: do not utilize information received outside of the
permissible broadcasting frequency ranges, do not pass this onto third
parties or do not use this improperly.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest HG00708A and is the answer not in the manual?

Silvercrest HG00708A Specifications

General IconGeneral
BrandSilvercrest
ModelHG00708A
CategoryClock Radio
LanguageEnglish

Related product manuals