SLM 5 A1
■ 50
│
GB
│
IE
Handling and operation
Pairing the speaker with a Bluetooth
®
device
NOTE
► If you want to pair the loudspeaker with a Bluetooth
®
device,
the 3.5 mm jack socket may not be occupied.
When using the device for the first time, proceed as follows:
♦ Ensure that the speaker is switched off and the Bluetooth
®
device is switched on.
♦ Set the Bluetooth
®
device so that it scans for other Bluetooth
®
devices. A detailed description of how to do this can be found in
the operating instructions for your Bluetooth
®
device.
♦ Press and hold the
button for about 3 seconds to turn the
speaker on. You will immediately hear a rising sequence of beeps
and the operating/charging LED flashes blue and orange
twice. Then you will hear a beep and the operating/charging
LED flashes alternatively orange und blue. The Bluetooth
®
function is now activated automatically.
♦ Select the entry
from the list of found devices on your
Bluetooth
®
device and, if required, enter the code to
connect the two devices. You will hear a beep and the operating/
charging LED flashes blue every 3 seconds once the
connection has been successfully established.
To Next Page
Loading...
