16 GB/IE/NI
If the product is off, press the button
7
until the signal
LED
6
lights up green and a signal tone sequence sounds.
Switch the playback device on and start playback.
Set the highest possible volume on the playback device.
Then adjust the volume with the +/- buttons
12
11
on the
speaker.
Switching between AUX-in
and Bluetooth
®
connections
To resume music playback via Bluetooth
®
connection
unplug the AUX cable
14
from the AUX-in jack
4
. The
product will then search for the previously paired playback
device (if any) and re-establish the Bluetooth
®
connection
automatically.
True Wireless Stereo TWS pairing
NOTE: This function is only available when the two
speakers are identical (same model number).
Turn on both speakers and make sure they are both not
connected to another device via Bluetooth
®
. At this moment,
neither of the speakers is actively coupled with a playback
device.
Press the
button
8
on one of the products which will then
by default set it as the “primary“ unit. A beep will sound.
When pairing between both products has been carried out
successfully, the LED
6
of the connected “secondary“ unit
stops flashing and a sequence of beeps will sound.
The “primary“ unit LED
6
will still be flashing waiting to
pair with the playback device. Once the “primaryr“ unit
has successfully paired with the playback device both
the “primary“ and “secondary“ units can be played and
controlled synchronously during Bluetooth
®
playback mode.
Press the
button
8
again to break the TWS pairing
connection, the LED
6
on the connected “secondary“ unit
flashes and a signal tone sequence sounds.
NOTE: The product which had its button
8
pressed first
will become the “primary“ unit (in the left audio channel), and
the other unit will then by default becone the “secondary“ unit
(in the right audio channnel).
PartyPlay function
PartyPlay is a new feature that allows you to connect more than
2 speakers together and up to a total of 10 speakers to play
music at the same time.
To Next Page
Loading...
