21 GB/IE/NI
Using the USB cable
56
, connect the product to a USB charging
device or a USB device. The LED charge display
7
will light
up red during charging, and the notice
will show in the LCD
touch display
5
. The notice will only appear if the product
is switched on during the charging process. If the product is
switched off during the charging process, only the LED charge
display
7
will continuously light up red.
A fully drained rechargeable battery requires approx. 3 hours
to recharge. The LED charge display
7
turns off automatically
as soon as the charging process is complete. The battery status
symbol
14
,
31
is shown on the LCD touch display
5
.
Note: Prior to every use, check the display for the battery status
14
,
31
and charge the battery if necessary.
If the battery drains fully while the camera is in use, the product
saves the current photo / video and then turns itself off.
Replacing the rechargeable battery
Switch the product off as described in the chapter “Switching the
product on and off“.
Open the battery compartment cover
11
by pushing it to the side
and lifting it up.
Remove the defective rechargeable battery / the battery you wish
to replace by carefully pulling the plastic strip.
Insert the new rechargeable battery (see chapter “Technical data“)
and close the battery compartment cover
11
again, so that it
clicks into place.
To Next Page
Loading...
