81 GB/IE/NI
Make sure that the waterproof case
59
is dry and clean. Ensure
in particular that the seal is clean and undamaged.
Insert the product and make sure that the lens
4
fits exactly in
the lens opening.
Re-seal the waterproof case
59
by hooking part of the locking
clip
58
in the lid and carefully turning the other part of the lock-
ing clip
58
downwards until you hear it click into place.
Fitting the helmet mount
Note: Before fitting the helmet mount using the provided 3M adhe-
sive labels for mounting
53
(e.g. on a bicycle helmet), you must read
the relevant helmet manufacturer‘s instructions and the safety notes.
Ensure that the use of the helmet mount and the fitting accessories is
permitted and that the protective effect of the bicycle helmet will not
be adversely affected by these.
You can use and mount the product in different ways with the acces-
sories included. For assembly examples see figure D.
Note: Clean the mounting surface with a degreasing and non-abrasive
/
non-chemical detergent before you affix the helmet mount
51
,
52
.
To Next Page
Loading...
