English -
. Attaching the mounting clip
` Insert the mounting clip into the device as shown in Fig. F.
The mounting clip must click audibly into place.
The mounting clip does not need to be removed from the device for further use. Should it
become necessary to remove the mounting clip, proceed as follows:
` Use a suitable object, such as a crosshead screwdriver, to press the lock-in point in the
upper opening of the mounting clip.
` Pull the mounting clip down and out of the device.
. Attach bicycle speaker
The bicycle bracket is suitable for all standard handlebars.
` Loosen the mounting screw of the bicycle bracket (B), making sure that the small lock-
ing nut on the underside does not get lost.
` Place a non-slip rubber pad suitable for the handlebars in the bicycle bracket.
` Attach the bicycle bracket to the handlebar of the bicycle and align the bracket so that
you can operate the bicycle speaker optimally (see Fig. G).
` Tighten the mounting screw firmly again.
` Slide the bicycle speaker onto the bicycle bracket so that the mounting clip goes over
the track of the bicycle bracket and then clicks into place audibly. (see Fig. H).
. Operating LED
The operating LED () indicates the following operating states:
Signal Meaning
Operating light flashes blue quickly Pairing mode
Operating light lights up blue Paired, playback
Operating light flashes blue Playback is paused
Indicator lamp lights purple Charging is in progress, in ON mode (playback
paused)
Operating light lights up red Charging in progress, in OFF mode
Operating light flashes red Flat battery
Indicator lamp lights green Playback in Aux mode
Indicator lamp flashes green Playback paused in Aux mode
To Next Page
Loading...