Silvercrest SBKG 40 A1 - Control Elements; Headphone Components Identification

GB
│
IE
│
11 ■
SBKG 40 A1
Charging the internal battery
NOTE
► Before using the headphones, the integrated battery must be com-
pletely charged.
CAUTION
► Charge the headphones only in dry indoor spaces.
► Use only the supplied USB charging cable
q to charge the head-
phones.
► Disconnect the USB charging cable
q when charging is complete.
♦ Make sure that the headphones are switched off. To switch off the
headphones, press the
button 4 for about 2seconds until a beep
sounds and the LED6 goes out.
♦ Connect the USB-A plug on the USB charging cable
q to a USB
mains adapter or a USB port on your computer.
♦ Connect the USB-C plug of the USB charging cable q to the
USB-C charging port DC IN 7 on the headphones.
NOTE
► The LED
6 lights up white during charging. When the battery is fully
charged, the LED 6 switches off.
► Charging takes about 2.5 hours at a charging current of 500 mA.
When the battery is fully charged, you can play back music at a me-
dium volume (85 dB(A)) for up to 15 hours. The playback time may
vary depending on level of the volume.
► When the battery is empty, the LED
6 flashes white once every 10
seconds and a signal tone sounds. The headphones then switch off
automatically.