Silvercrest SBKG 40 A1 - Setting Up; Unpacking and Content Verification

■ 12
│
GB
│
IE
SBKG 40 A1
Handling and operation
Switching the headphones on/off
♦ Press the button 4 for about 2 seconds to switch on the head-
phones. You will hear a beep and the LED 6 lights up blue for
approx. 2 seconds. Afterwards, the LED 6 flashes blue and white. The
headphones are now in pairing mode.
♦ To switch off the headphones, press the
button 4 again for about
2 seconds until you hear a beep and the LED
6 goes out.
Wearing the headphones
♦ When putting the headphones on, please note the markings “R” (right)
and “L” (left) on the inside of the adjustable headband 1.
♦ Adjust the headband
1 so that it fits your head comfortably and the
earpieces 2 cover your ears.
Pairing/unpairing the headphones with a Bluetooth
®
device
Before you can use the headphones with the Bluetooth
®
function, you must
pair them with a compatible Bluetooth
®
device.
♦ Switch on the headphones as described above to activate pairing mode.
♦ Set the Bluetooth
®
playback device so that it scans for Bluetooth
®
devices. A detailed description of how to do this can be found in the
operating manual for your Bluetooth
®
playback device.
♦ Select the entry SBKG 40 A1 from the list of devices found on your
Bluetooth
®
playback device and, if required, enter the code 0000
to connect the two devices. If the pairing is successful, you will hear a
series of beeps and the LED 6 will flash blue every 5 seconds.