Silvercrest SBL3 D1 - Mute; Setting the Alarm; Setting the Time

SilverCrest SBL 3 D1
52 - English
9.5.4 Mute
Press the ▸II button (5) briefly to enable or disable the mute function.
9.6 Setting the time
The time can only be set in alarm mode. To set the time, proceed as
follows:
• Switch the speaker on by pressing and holding the button (1) for
approx. 2 seconds.
• Press the M button (9) several times until "AL" (14) is shown on the
display (2) and (12) or “FM” (13) goes out.
• Press and hold the M button (9) for approx. 2 seconds.
• The hour display flashes and you can now use the I◂◂ (8) and ▸▸I (4)
buttons to set the hour. You can keep the buttons pressed to accelerate
the digits count. Press the ▸II button (5) briefly to apply the setting.
• The minute display flashes and you can now use the I◂◂ (8) and ▸▸I (4)
buttons to set the minutes. You can keep the buttons pressed to
accelerate the digits count. Press the ▸II button (5) briefly to apply the
setting.
9.7 Setting the alarm
The alarm can only be set in alarm mode. To set the alarm, proceed as
follows:
• Switch the speaker on by pressing and holding the button (1) for
approx. 2 seconds.