SilverCrest SBL 3 D1
English - 49
Press and hold the button (1) for approx. 2 seconds to switch the
speaker off. A sequence of beeps can be heard and the display (2) reads
“OFF”.
If no button is pressed for approx. 2 minutes, the display
(2) switches off.
9.2 Adjusting the volume
Briefly press the I◂◂ (8) or ▸▸I (4) buttons to adjust the volume to the
desired level. The current volume setting is shown on the display (2). A
beep sounds when the minimum or maximum volume is reached. The
speaker will always switch on at the volume it was at when it was switched
off.
9.3 Selecting the mode
Press the M button (9) several times to toggle through the different modes.
The current mode is shown on the display (2). The following modes are
available: (Bluetooth
®
), FM (radio) and AL (alarm).
9.4 Bluetooth
®
mode
Via Bluetooth
®
, you can pair a Bluetooth
®
-compatible music player (such
as a smartphone or MP3 player) with the speaker. After pairing, you can
play the music on the speaker and control basic player functions remotely
using the buttons on the speaker.
Proceed as follows to pair the speaker with your mobile phone or player:
To Next Page
Loading...
