SBLD 28 A1
GB
│
IE
│
NI
│
13 ■
Operation of the buttons
Button Function
► Press briefly to play/pause the music.
► Press and hold for 2 seconds until you hear a beep to
end the Bluetooth
®
connection. The device must be
re-coupled with your Bluetooth
®
device before you
can reuse it.
/
► Press briefly to increase the volume. When you reach
the maximum volume you will hear a short beep.
► Press and hold for 2 seconds to jump to the next track.
/
► Press briefly to decrease the volume. When you reach
the minimum volume (mute), you will hear a short
beep.
► Press and hold for 2 seconds to jump back to begin-
ning of the track. Press and hold again for 2 seconds
within 2 seconds to jump to the previous track.
This button controls the device lighting in a cycle as fol-
lows:
► Switch on the device: the lighting is switched off.
► Press once: The lighting pulses in a multicoloured
colour change.
► Press twice: The lighting pulses in a single-coloured
colour change to the volume of the music.
► Press three times: The lighting pulses in a multicoloured
colour change to the volume of the music.
► Press again: The lighting is switched off and the cycle
begins again the next time you press the button.
To Next Page
Loading...
