To Next Page

To Previous Page

SBTF 10 C2

Rejection of a call

● Press the multi-function button 6 for 3 seconds to

reject an incoming telephone call.

Adjusting the volume of the hands-free appliance

You can adjust the sound volume level of the hands free

device with the +/- buttons 3.

● During a call, repeatedly press the + resp. - buttons 3

until the desired sound volume level is obtained. The

attainment of the maximum sound volume level is indi-

cated by a short signal tone.

Charging 5 V Devices

● Check the max. input voltage (5V) and the max. power

input (1000 mA) of the device which you want to charge.

For this, consult the operating manual of the device.

● Connect the device to be charged with the USB port 4

on the hands free device. The device now receives its

power supply from the hands free device. If the device

is equipped with a charging indicator light, this will in-

dicate that the device is being charged.

Note:

If the power supply does not activate automatically, you

should disconnect the USB cable from the USB port 4

and re-connect it.

Troubleshooting

If you cannot connect the hands-free appliance with a

compatible mobile telephone, proceed as follows:

● Ensure that the Bluetooth

function in the mobile

telephone is activated.

● Ensure that the hands-free appliance is correctly

installed, switched on and supplied with electricity.

● If you use several Bluetooth

appliances, ensure that

a previously created Bluetooth

connection of the

mobile telephone is separated.

IB_93813_SBTF10C2_LB7.indb 11IB_93813_SBTF10C2_LB7.indb 11 10.10.13 11:4510.10.13 11:45

Silvercrest SBTF 10 C2 Operating Intructions

Other manuals for Silvercrest SBTF 10 C2