Silvercrest SCW 5 A1 - Removing; Fixing the Adapter

SilverCrest SCW 5 A1
66 - English
 Open the water-resistant case and remove the back cover.
 Next mount the desired back cover by inverting the above steps.
Removing / fixing the adapter
By default, an adapter is fixed to the water-resistant case and another adapter to the water-
resistant back cover. These adapters allow mounting the water-resistant case and the other
accessories. If you need to mount the adapter on the open back cover, you can remove it
and fix it at the desired position. Proceed as follows:
 Remove the desired adapter by untightening the four screws.