Silvercrest SCW 5 A1 - Troubleshooting and Maintenance; Common Issues and Solutions

SilverCrest SCW 5 A1
English - 69
 Press the clip on the adhesive socket to remove the swivel holder from the adhesive
socket. You can leave the adhesive socket on the mounting location if you want to use
the camcorder at this location again.
 To be able to remove the swivel holder from the water-resistant case you have to
remove the unlock catch first. To do this, fully unscrew the fixing screw and remove the
unlock catch.
 Press the clip on the swivel holder to remove the swivel holder from the water-resistant
case.
To guarantee a good adhesive fixation, the cleaned mounting surface
must be free of dust, oil and grease.
Replacing the adhesive pad
The camcorder is supplied with three spare adhesive pads. If the adhesive strength of one
adhesive socket weakens, you can replace the adhesive pad. Proceed as follows:
 Fully remove the adhesive pad from the adhesive socket.
 Remove the white film from the adhesive pad. This is the side that will be permanently
fixed.
 Next put the adhesive pad onto the adhesive socket.
To guarantee a good adhesive fixation, the cleaned mounting surface
must be free of dust, oil and grease.