Silvercrest SDBK 2400 E4 - Operation - Part 3 and Maintenance; Steam Jet Function; Cleaning and Self-Cleaning

10
GB
7. Finish ironing, set the temperature con-
troller|17 to MIN, set the steam flow
rate controller|3 to and pull out the
mains plug.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank|15 through the filling open-
ing in the water tank (under the lid|2).
7.6 Steam jet function
The steam jet function requires a high tem-
perature. Select a temperature setting be-
tween and MAX. For this purpose, the
water tank|15 must be at least one quarter
full. The steam flow rate controller|3 is locat-
ed to the left on the symbol .
• Press the steam jet button while the
steam iron glides over the item of laun-
dry|4 .
• Wait a few seconds before you press
the steam jet button|4 again.
NOTE:
• For smoothing items of clothing that are
hanging up, you can use the steam jet
Button in a vertical position.
8. Cleaning
DANGER!
~ Pull the mains plug out of the wall socket
before you clean the steam iron.
~ Allow the device to cool down before
cleaning.
CAUTION:
~ Do not use any astringent or abrasive
cleaning agents.
Cleaning the device
• For cleaning the device, use a soft,
moistened cloth.
• Dirt can be removed from the sole
plate|20 using commercially available
cleaning agents for chrome, silver or
stainless steel.
• Residues that have melted on can be re-
moved by heating the steam iron up to
the MAX setting and then ironing an
old cotton cloth.
Self-cleaning
CAUTION:
~ Do not put vinegar, limescale remover
or any other additives into the water
tank|15. Additives can damage the de-
vice.
If you use tap water, you should run the self-
cleaning cycle after every use. Otherwise
use the self-cleaning cycle at least twice per
month.
1. Fill the water tank|15.
2. Place the steam iron in the stand|7.
3. Connect the mains plug with the wall
socket.
4. Set the steam flow rate controller|3 to
and set the temperature control-
ler|17 to MAX.
5. Wait until the temperature control
lamp|14 goes out.
6. The switch|11 is in the position . Pick
up the steam iron together with the
stand|7.
7. While doing so, hold the device hori-
zontally over a heat-resistant household
dish.
8. Press the |18 SELF CLEAN button and
hold it down. Limescale residues will now
be ejected with steam and hot water from
the steam outlet holes in the sole plate|
20 .
Hold the button down until no more steam
or water emerges.
BB1$6B%XHJHOHLVHQB%ERRN6HLWH0RQWDJ$XJXVW