8
GB
• If your tap water is of medium hardness
or higher, please mix in some distilled
water:
• Your local waterworks will inform you of
the hardness of your water.
1. Disconnect the mains plug10 from the
wall socket.
2. Turn the temperature controller4 to
MIN.
3. Figure A: push the unlocking mecha-
nism6 of the water tank1 towards the
rear.
4. Hold the water tank1 by the side
lugs13.
5. Figure A: lift the water tank1 up ver-
tically. The temperature controller4 re-
mains on the device.
6. Open the cover2 over the filler open-
ing3.
7. Fill in the water with the measuring
beaker15 up to the MAX mark on the
water tank1.
8. Close the cover2 over the filler open-
ing3.
9. Place the water tank1 onto the device.
The water tank must be heard to en-
gage with the unlocking mechanism6.
6.3 Set iron temperature
1. Set the desired temperature using the
temperature controller4.
2. The control lamp
7
is lit for as long as the
device is heating. It goes out when the set
temperature has been reached. You can
then begin ironing.
6.4 Steam jet function
DANGER! Risk of injury
through burning!
~ Warning: risk of burns from steam and
sprayed hot water when using the
steam jet button11. When using the
steam jet, always point the sole
plate14 towards the item of laundry or
ironing board.
NOTES:
• The steam jet function requires a high
temperature.
• The steam jet function can be used with
or without the brush attachment17.
1. Select a setting for the temperature con-
troller4 between and MAX.
The control lamp7 goes on.
2. Start ironing as soon as the tempera-
ture has been reached and the control
lamp7 goes off.
Hardness of the
tap water
Distilled water :
tap water
very soft/soft 0
medium 1 : 1
hard 2 : 1
very hard 3 : 1
Mainte-
nance
symbol
Type of
tissue
Tempera-
ture
controller
Man-made fi-
bre, e.g. vis-
cose,
polyester
Silk, wool
Cotton, linen
BB&3(B%ERRN6HLWH0RQWDJ-XOL
To Next Page
Loading...
Need help?
General
