Silvercrest SDRB 1000 C1 User Manual

7
GB
5. Before using for the
first time
NOTE: you may notice an odour when us-
ing for the first time. This is a result of the
manufacturing process and is not a defect
with the device. Ensure adequate ventila-
tion.
1. Ensure that you have pulled out the
mains plug10.
2. Figure A: push the unlocking mecha-
nism6 of the water tank1 towards the
rear.
3. Hold the water tank1 by the side
lugs13.
4. Figure A: lift the water tank1 up ver-
tically. The temperature controller4 re-
mains on the device.
5. Open the cover2 over the filler open-
ing3.
6. Fill the water tank1 to about halfway
and then close the cover2.
7. Place the water tank1 onto the device.
The water tank must be heard to en-
gage with the unlocking mechanism6.
8. Insert the mains plug10 into a ground-
ed power socket corresponding to the
technical data.
9. Set the temperature controller4 to
MAX. The temperature control lamp7
lights up.
10. As soon as the device has reached the
set temperature, the control lamp7
goes off. Iron an old cotton cloth with
repeat jets of steam until the water
tank1 is empty.
6. Operation
6.1 Care instructions
• If the care instructions in the item of
clothing state that it must not be ironed
( symbol), you must not use the
steam brush on the item of clothing.
Otherwise the garment might be dam-
aged.
• Do not treat any leather, velvet, impreg-
nated furniture or materials which are
sensitive to steam. Otherwise the textile/
piece of furniture might be damaged.
• The steam brush can be used for many
types of garment. Caution is required in
the case of materials which are sensitive
to heat, such as synthetic materials (e.g.
polyamide or rayon). With these materi-
als you should test beforehand in a spot
which is not visible (e.g. the inside of a
seam) whether the hot steam damages
the material. Do not touch these materi-
als directly with the hot sole plate14.
You should only use the steam jet func-
tion.
6.2 Filling the water tank
DANGER! Risk of electric
shock due to moisture!
~ Pull the mains plug10 out of the socket
before you fill up the water tank1.
DANGER! Risk of injury
through burning!
~ The filler opening of the water tank must
not be opened while the iron is being
used.
• Use clean tap water without any addi-
tives (e.g. vinegar, limescale remover,
starch, perfume, softener).
BB&3(B%ERRN6HLWH0RQWDJ-XOL

Silvercrest SDRB 1000 C1 Specifications

General

Brand	Silvercrest
Model	SDRB 1000 C1
Category	Steam Cleaner
Language	English