11
GB
8. Storage
1. Set the temperature controller4 to
MIN.
2. Pull out the mains plug10.
3. Allow the device to cool down.
4. Open the cover2 over the filler open-
ing3.
5. Pour any remaining water out of the
water tank1 through the filler open-
ing3.
6. Store the steam brush by hanging it up
on the eyelet9.
9. Troubleshooting
If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
~ Do not attempt to repair the device your-
self under any circumstances.
10. Disposal
The symbol showing a wheel-
ie bin crossed through indi-
cates that the product
requires separate refuse col-
lection in the European Un-
ion. This applies to the
product and all accessories marked with this
symbol. Products identified with this symbol
may not be discarded with normal house-
hold waste, but must be taken to a collection
point for recycling electric and electronic ap-
pliances. Recycling helps to reduce the con-
sumption of raw materials and protect the
environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.
Fault
Possible causes /
Action
No function
• Connect the device to
the mains power supply.
• Use the temperature
controller4 to turn up
the temperature.
Little or no
steam
• Fill the water tank
1
.
•
Select a setting for the
temperature control-
ler4 between
and MAX. The control
lamp goes on.
• Descale the device.
Steam jet is
not working.
• Fill the water tank
1
.
• Select a setting for the
temperature control-
ler4 between
and MAX.
• It may be necessary to
press repeatedly to trig-
ger the first jet of
steam.
• Leave a pause of a few
seconds between steam
jets.
Fault
Possible causes /
Action
BB&3(B%ERRN6HLWH0RQWDJ-XOL
To Next Page
Loading...
Need help?
General
