Silvercrest SEM 1100 C4 User Manual

GB
│
IE
│
11 ■
SEM 1100 C4
3) Place the sieve holder i in the appliance by inserting the “INSERT” mark,
which is located next to the hot water shower r, into the appliance and then
turning it clockwise until the handle of the sieve holder i is facing the front
(“LOCK” mark).
4) Place a cup under the sieve holder i.
5) Close the steam control 7 (turn it as far as it will go in the direction of the “
▯ “
symbol).
6) Switch the appliance on using the On/Off switch 1. The operating lamp z
lights up. The “Espresso” control lamp t flashes.
The appliance starts to heat up.
7) As soon as the “Espresso” control lamp t lights up continuously, press the
“Espresso” button
3. Let the water run through for about 1 minute.
NOTE
► You may need to empty the cup in between. Interrupt the process by pressing
the "Espresso" button
3. Empty the cup and press the "Espresso" button
3 again so that water flows through the appliance.
8) After about 1 minute, stop the pump by pressing the “Espresso” button
3
again.
9) Wait until the “Espresso” control lamp t lights up continuously (if it is not
already lit). The warming-up is concluded. You can now prepare espresso.
Heating up before every use
Before you can prepare an espresso or cappuccino, the appliance must be
heated up.
1) Switch the appliance on using the On/Off switch 1. The operating lamp z
lights up. The “Espresso” control lamp t flashes. Make sure that the steam
control 7 is turned in the direction of the
“▯” as far as the stop.
2) Place the sieve holder i in the appliance by inserting the “INSERT” mark,
which is located next to the hot water shower r, into the appliance and then
turning it clockwise until the handle of the sieve holder i is facing the front
(“LOCK” mark).
3) Press the “Espresso” button
3 so that the appliance draws water from
the water tank 9. As soon as water starts exiting the openings in the sieve
holder, press the “Espresso” button 3 again to stop the pump.
4) Wait until the “Espresso” control lamp t lights up continuously.
5) Press the “Espresso” button
3 again and allow hot water to flow
through for 20 seconds before stopping the pump again.
The preheating process is completed. You can now make an espresso/cappuccino.

Silvercrest SEM 1100 C4 Specifications

General

Brand	Silvercrest
Model	SEM 1100 C4
Category	Coffee Maker
Language	English