EasyManuals Logo

Silvercrest SFE450A1-05/10-V2 User Manual

Silvercrest SFE450A1-05/10-V2
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
7
GB
4. Items supplied
1 Dehumidifier with water tank 5
1Hose 24
1 Garden hose adapter 25
1 Set of operating instructions
5. How to use
Remove all packing material.
Remove all transport packing material.
Strip off the foil from the operating pan-
el.
Check to ensure that all parts are pres-
ent and undamaged.
1. Place the device on a level, dry and solid
surface.
2. Let the device rest in its working position
for about 30 minutes, so that the coolant
fluid can settle.
3. Check that the float in the water tank
26
can move freely. To do this, pull out the
empty water tank
5
and turn it upside
down so that the float moves.
4. Check that the water tank
5
is inserted
correctly. If it is installed incorrectly, or if
the water tank has been removed, the
LED
13
TANK FULL will illuminate.
5. Connect the mains plug
11
to a ground-
ed power socket.
6. Notes on operation
If the relative humidity in residential
rooms is continuously excessive, the
cause should be found and rectified.
(Continuous ventilation - i.e. for several
years - is generally not reasonable.)
The optimum ambient temperature for
removing humidity from the air is 5°C
to 35°C. Below 5°C, the use of a de-
humidifier is not helpful, as there is only
relatively little humidity in the air.
During operation, the room temperature
may rise by between 1°C and 4°C,
depending on room size. This is normal.
Automatic defrosting
In order to prevent the device from freezing
over while in continuous operation, it de-
frosts itself automatically. To do this, the de-
humidification process is interrupted, and
the motor switches to its highest setting.
The intervals at which this happens vary.
7. Operation
7.1 Switching on and off
By pressing the button STAND-BY 18,
you can switch the device on and off.
The corresponding LEDs illuminate or go
out.
- The device will start with the setting
last selected.
If a timer has been set, the device will
shut down after the time has run out (1-
24 hours).
If a value has been set for relative hu-
midity in the TARGET-HUMIDITY mode,
the device will stop when the value has
been reached, and re-start when the val-
ue is exceeded again.
The device switches off when the water
tank is full or has been removed.
Conditions
Defrosting
Temperature:
over 20°C
no defrosting
Temperature:
12°C to 20°C
after 40 minutes dehu-
midification,
8 minutes defrosting
Temperature:
5°C to 12°C
after 25 minutes dehu-
midification,
10 minutes defrosting
Temperature:
under 5°C
operation not possible
__CPE111670_B6.book Seite 7 Donnerstag, 12. März 2015 11:50 11

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SFE450A1-05/10-V2 and is the answer not in the manual?

Silvercrest SFE450A1-05/10-V2 Specifications

General IconGeneral
BrandSilvercrest
ModelSFE450A1-05/10-V2
CategoryDehumidifier
LanguageEnglish

Related product manuals