GB
│
IE
│
NI
│
17 ■
SFM 850 A2
■ Clean the appliance lid in warm water using a mild detergent. Rinse the ap-
pliance lid off with clear water. Dry the appliance lid well and then place it
upright on its side so that any excess water still inside the lid can drain away.
Be aware that the lid must be completely dry before re-use!
■ Clean the permanent metal filter in warm water with a little detergent,
then rinse it with clear water.
4) Dry all parts well before assembly.
5) Replace the permanent metal filter in the cavity in the device lid and close
cover over the permanent metal filter .
6) Replace the lid on the appliance so that the hinges grip into the hinge supports
on the rear side of the appliance and sit firmly in place.
NOTE
Any other servicing should be performed by an authorized service representative
or Customer Service.
Storage
1) Lift or carry the appliance using the side handles on the housing.
2) Wrap the power cable around the cable retainer on the rear of the ap-
pliance. Push one of the pins of the mains plug into one of the holes on the
cable retainer to hold the mains plug in place:
3) The handle of the frying basket -can be removed for storage and laid
in the frying basket - so that frying basket - can be placed in the deep fat
fryer.
4) Store the appliance with the appliance lid closed. This will keep the inside of
the deep fat fryer clean and free of dust.
To Next Page
Loading...
Need help?
General
