26 GB/IE/NI
Then release the
MEASURE button
5
.
The measured value
appears on the display
and the end of the
measuring process is indicated by a short beep
(when the key tone is activated). When the meas-
urement type symbol stops flashing, the next
measurement can be taken. This takes approx.
5 seconds.
If the measured value lies within the normal range
(<38°C / 100.4°F), the LED above the display
lights up green for 3 seconds. If the measured
value is higher than this (≥ 38°C/100.4°F = fe-
ver), the LED will light up red.
If you have activated Bluetooth
®
data transfer, the
data will be transferred after the measurement.
The thermometer displays the symbol for Bluetooth
®
during transfer.
Note: The “HealthForYou“ app must be activated
for transfer to occur. If the current data is not dis-
played on your smartphone, repeat the transfer
process as described in the chapter “transferring
measured values“.
The device will switch off automatically after 60
seconds (if no Bluetooth
®
connection is available)
or press the ON / OFF / MEASURE button
8
for 5 seconds to switch it off.
338571_2001_silv_Multifunktionsthermometer_Content_IE_NI_DK_BE_NL.indd 26338571_2001_silv_Multifunktionsthermometer_Content_IE_NI_DK_BE_NL.indd 26 26.05.20 10:5526.05.20 10:55
To Next Page
Loading...
